In fiber optic cable installation, the network’s success depends on how the cables are attached to the system. When done correctly, optical signals can easily move through the linked cables with a low risk of power loss. Fiber optic pigtail is the preferred way to join optical fiber and is used in 99% of single-mode applications. (source)

A fiber optic pigtail is a fiber optic cable that has a factory-installed connector on one end. As a result, one side can be melted with optical fiber cables, while the side where the connector is attached can be linked to various pieces of equipment. Mechanical splicing or fusion is used to terminate fiber optic cables with a pigtail. To get the best possible performance, high-quality pigtail cables are used along with correct fusion splicing practices. Pigtails are often found in fiber optics management equipment such as distribution boxes, fiber terminal boxes, and ODF. Since the connector end is attached in the factory, fiber pigtail tends to be better quality compared to field-terminated cables.

A fiber optic pigtail has one end left empty with a fiber connector installed on the other. On the other hand, both ends of a fiber patch cord will be terminated with a fiber optic connector for each. Patch cord cables are also typically jacketed, while conversely, fiber pigtail cables usually come unjacketed since they tend to be spliced and protected in a splice tray. It is possible to cut a patch cord into two pieces to make two fiber pigtails, which is a preferred method for some installers who want to avoid the problem of testing pigtail cables in the field since it is easier to test the performance of a fiber patch.

There are various types of fiber optic pigtails available. These are grouped by either connector type, fiber type, fiber count, or application environment.

There are different types of fiber optic pigtail connectors where the cable is terminated at the end. The most common options are LC, SC, ST, FC, MT-RJ, and E2000 fiber pigtails. Each of them has different structures and appearances, with their own advantages in various systems and applications.

Fiber optic pigtails can be divided into two different types: Single-mode and multimode. Single-mode fiber is typically yellow, while multimode is usually orange. Multimode fiber optic pigtails are terminated with multimode fiber optic connectors at one end and use 62.5/125-micron or 50/125-micron bulk multimode cables.

Fiber optic pigtails come in a range of fiber counts, with 1, 2, 4, 6, 8, 12, 24, and 48 stand fiber counts available. A simplex fiber pigtail is available in one fiber and a connector on one end, while a duplex fiber optic pigtail offers two fibers and two connectors on the end. To mark polarity, each fiber is either marked with A or B, or different connector boot colors are used.

Some fiber optic pigtails are specifically designed and installed to withstand extreme or harsh weather or environments. These fiber pigtail options are typically either waterproof or armored.

Fiber optic pigtails are used to splice with the fiber in order to connect them with various types of equipment or patch panels. They provide a reliable, feasible solution for effective fiber cable termination with a range of types available for almost any type of application or use. As a result, they are key for saving both operating costs and labor time for installers.

Your email address will not be published. Required fields are marked *

Login to your account below

Fill the forms below to register

Please enter your username or email address to reset your password.